0333 300 1293

Phone Lines Open Mon - Fri 10 am - 4.30 pm (excluding bank holidays)

How to replace the speed control PCB on a Henry Hoover

Video Transcript:

Hi, I'm Lee from Ransom Spares and in this video I'm going to show you how to replace the PCB on a Henry Vacuum Cleaner.

First of all we need to remove Henry's head by removing the two clips.  Next we need to remove the 7 screws and seperate the motor cover from the motor housing.

Once the motor housing cover is removed we can now see the PCB.  Depending if your Henry Vacuum Cleaner is a 2 speed will depend on which PCB you have fitted; it will either be orange or green.  Remove the wires from the PCB noting the order in which they came off.

Now we can fit the new PCB to Henry.  Next we need to refit the motor cover and re-fit the 7 screws.  Henry's head can now be replaced and the 2 clips re-fastened in place.

There you go - that's how to fit a new PCB to a Henry Vacuum Cleaner.  Remember you can buy all your Henry Vacuum Cleaner Spares online at Ransom Spares.  Thanks for watching.

By Lee Gilbert