Next Day Delivery
Order by 4pm
Genuine Parts
Quality guaranteed
UK & Ireland
Fast shipping
Expert Help
Parts advice available
Bosch
Suitable for Bosch, Balay, Constructa, Lord, Neff
Stock Code: 58880
£9.58 ex. VAT
Transfers motor power to turn the drum.
Tick the symptoms your appliance is showing. We’ll tell you how confident we are this part is the fix.
Error codes are model dependent, so the same brand may have more than one listed.
| Code | Brand | What it means | Confidence |
|---|---|---|---|
| F4 | Bosch | Means a motor-related fault, with some models interpreting it as a drainage timeout. It is usually caused by worn carbon brushes, faulty motor wiring, or a malfunctioning control module. | Medium |
| F63 | Bosch | Means a critical motor or control board failure, signalling a communication issue between the motor and the main electronics. It is usually caused by worn motor brushes or a faulty motor control module. | Medium |
| F48 | Siemens | Means the motor cannot turn, or the control board loses connection with the motor. It is usually caused by motor failure, electronic control module issues, or damaged wiring. | Medium |
| F7 | Siemens | Means there is a motor fault or a failure to reach the correct speed during a cycle, which often cuts out the spin, or on some models a door lock issue. It is usually caused by a motor fault, a pump that is not operating, or a door that is not locking. | High |
| F9 | Siemens | Means the motor cannot reach the required speed or is not communicating with the control module, often because of a severe unbalanced load that prevented the drum from spinning. It is usually caused by a motor fault, a control board fault, or an unbalanced load. | High |
Bosch
Means a motor-related fault, with some models interpreting it as a drainage timeout. It is usually caused by worn carbon brushes, faulty motor wiring, or a malfunctioning control module.
Bosch
Means a critical motor or control board failure, signalling a communication issue between the motor and the main electronics. It is usually caused by worn motor brushes or a faulty motor control module.
Siemens
Means the motor cannot turn, or the control board loses connection with the motor. It is usually caused by motor failure, electronic control module issues, or damaged wiring.
Siemens
Means there is a motor fault or a failure to reach the correct speed during a cycle, which often cuts out the spin, or on some models a door lock issue. It is usually caused by a motor fault, a pump that is not operating, or a door that is not locking.
Siemens
Means the motor cannot reach the required speed or is not communicating with the control module, often because of a severe unbalanced load that prevented the drum from spinning. It is usually caused by a motor fault, a control board fault, or an unbalanced load.
Don’t see your code? Different model years sometimes use different codes. Get in touch with our parts team and we’ll help you identify the right replacement.
General fitting guidance. The exact steps can vary slightly with the make and model of your washing machine.
Safety: Switch off and unplug at the mains before you start.
The following DIY repair video should assist you in fitting this part. However the exact procedure may differ depending on your make and model.
Safety Warining - Always unplug from the mains before carrying out any repairs.
Exactly the right part - made us realise how much the old belt had stretched - bit of an art to fit as it was so much tighter than the old belt, but it's doable with a bit of help from a YouTube guide! Recommend.