Next Day Delivery
Order by 4pm
Genuine Parts
Quality guaranteed
UK & Ireland
Fast shipping
Expert Help
Parts advice available
Whirlpool
Suitable for Whirlpool, Bauknecht, Hotpoint, Ignis, Laden
Stock Code: 592828
£30.21 ex. VAT
Pumps the collected water up to the container or drain.
Tick the symptoms your appliance is showing. We’ll tell you how confident we are this part is the fix.
Error codes are model dependent, so the same brand may have more than one listed.
| Code | Brand | What it means | Confidence |
|---|---|---|---|
| F11 | Hotpoint | Means a pump circuit fault, where the pump is disconnected, blocked, or faulty and water is not pumping out. It is usually caused by an open circuit in the pump system. | High |
| F4 | Hotpoint | Means the pump is running when it should not be, suggesting a water drainage problem or a heater circuit fault. It is usually caused by moisture causing a short circuit in the pump circuit, or a clogged pump filter preventing proper drainage. | High |
| F5 | Hotpoint | Means a drainage problem where the pump is not working or a blockage is preventing water from draining. It is usually caused by a blocked filter, a clogged waste pipe, or a failed pump. | High |
| H20 | Hotpoint | Means a water drainage problem, signalling that the condenser water reservoir is full or that draining has failed. It is usually caused by a blocked drain pump, a blocked filter, debris accumulation, or a malfunctioning sensor. | High |
Hotpoint
Means a pump circuit fault, where the pump is disconnected, blocked, or faulty and water is not pumping out. It is usually caused by an open circuit in the pump system.
Hotpoint
Means the pump is running when it should not be, suggesting a water drainage problem or a heater circuit fault. It is usually caused by moisture causing a short circuit in the pump circuit, or a clogged pump filter preventing proper drainage.
Hotpoint
Means a drainage problem where the pump is not working or a blockage is preventing water from draining. It is usually caused by a blocked filter, a clogged waste pipe, or a failed pump.
Hotpoint
Means a water drainage problem, signalling that the condenser water reservoir is full or that draining has failed. It is usually caused by a blocked drain pump, a blocked filter, debris accumulation, or a malfunctioning sensor.
Don’t see your code? Different model years sometimes use different codes. Get in touch with our parts team and we’ll help you identify the right replacement.
General fitting guidance. The exact steps can vary slightly with the make and model of your tumble dryer.
Safety: Switch off and unplug at the mains before you start.
If your Tumble dryer isn't heating, or if water isn't being collected during a cycle it's pretty likely that you have a failed drain pump. Once you have diagnosed that your drain pump has failed, or isn't working correctly, you can easily order a replacement drain pump today from Ransom Spares. Once it arrives you'll be able to replace your pump simply using only a screwdriver.
Do not use the you-tube link provided as a definitive way of accessing the areas where the cabling is located. first couple are logical steps to access. Taking off the side panel completely different. Part works but was a pain to install.
Perfect replacement part for the Hotpoint condenser tumble dryer. Best value for the part compared to other sites. Easy ordering process and delivery time spot on.👍