Next Day Delivery
Order by 4pm
Genuine Parts
Quality guaranteed
UK & Ireland
Fast shipping
Expert Help
Parts advice available
Bosch
Suitable for Bosch, Balay, Constructa, Gaggenau, Koenic
Stock Code: 546299
£11.54 ex. VAT
Transfers motor power to turn the drum.
Tick the symptoms your appliance is showing. We’ll tell you how confident we are this part is the fix.
General fitting guidance. The exact steps can vary slightly with the make and model of your tumble dryer.
Safety: Switch off and unplug at the mains before you start.
This is a genuine tumble dryer belt. Has a section of H7 and is 1995 mm long.
Keeps the power flowing so your clothes tumble, spin, and come out fresh and clean every time. As the motor runs, the belt turns the drum smoothly, making sure your laundry gets evenly washed and dried.
If you're hearing squeals, screeching noises, or noticing the drum isn’t spinning properly—or at all—it could be a worn-out belt. Just swap it with this replacement part.
Check our video below on how to fit a new one.
This tumble dryer belt is from Bosch. Also fits Balay, Constructa, Gaggenau, Koenic, Lord, Neff, Novamatic, Pitsos, Profilo, Schulthess, and Siemens models.
Before ordering, please verify that this fits your model using our compatibility checker.
Please note that the following video will give you a guide on how to fit this part, however the exact fitting may differ depending on your make and model.
Safety Warning - Always unplug from the mains before carrying out any repairs.
Time consuming to fit because the whole machine has to be dismantled and the drum removed. However it is fairly straight forward job. Belt fits perfectly and the machine now works.
Perfect fit and delivered quickly. Was a pain to fit but that's an issue with the drier, not the belt itself.
Prompt delivery, belt looks like it is a good quality item. Taking the dryer apart and putting it back together again was a total pain but it is working again.
Ransome Spares video shows the correct procedure. It is essential to remove the drum to wriggle the belt behind the fan onto the motor pulley. The fan housing has to be removed, its clips are under the drum. The upside is: This is the perfect opportunity to de-fluff fans, ducts, sensors and the heater; lubricate the bearing and de-goop the pump and sump .
Great product exact replacement once machine was stripped down to allow fitting