AEG Tumble Dryer Condensation Water Pump Condenser8581258349217

AEG

Means a drainage, pump, or water level sensor fault, where water cannot move to the reservoir or drain hose. It is usually caused by clogged lint or condenser filters, a full water tank, a kinked drain hose, or a blocked pump.

AEG

Means a water drainage, pump, or blockage fault. It is usually caused by a clogged drain pump filter, a kinked or blocked drain hose, or a jammed pump impeller.

AEG

Means a drainage problem or a faulty water pump, where water cannot move to the top container. It is usually caused by a clogged filter, a blocked pump, or a faulty float switch.

AEG

Means a fault with the triac sensing circuit for the pump on the condensate drainage system, so the main control board cannot communicate with the pump. It is usually caused by a blocked pump, a malfunctioning float switch, or a faulty control board.

AEG

Means water leakage or accumulation in the base unit. It is usually caused by a clogged drain system or a door seal fault.

Electrolux

Means a water leak has filled the base tray and triggered the safety anti-flood switch, particularly on washer-dryer combos. It is usually caused by clogged filters or excessive detergent foam.

Zanussi

Means the machine is unable to empty water from the condenser unit, frequently displayed alongside E20 or E21. It is usually caused by a clogged filter, a kinked drain hose, or a faulty drain pump.

Zanussi

Means a drainage, pump, or software problem. It is usually caused by an incorrect external drain hose connection or a pumping fault, with the same fault family covering E20 pumping problems, E21 canister fill pump triac, and E22 triac sensing circuit.

Zanussi

Means the appliance is unable to remove water effectively, also encountered on washer dryer models with two beeps or flashes. It is usually caused by a pump or drainage fault, a clogged filter, a kinked drain hose, or a lint blockage.

Zanussi

Means a water drainage issue or a blocked condensate pump, with the dryer stopping for safety because water is not being removed efficiently. It is usually caused by a blocked filter, a clogged condenser unit, a kinked drain hose, or debris in the pump.

Zanussi

Means a problem with the water drainage system, specifically a faulty triac sensing circuit for the canister fill pump or a pump failure, leaving the condenser pump unable to transfer water to the reservoir. It is usually caused by a blockage or a faulty component.

Zanussi

Means an Aqua Control or water system failure where water has leaked into the base tray and the machine has entered safety mode to prevent flooding, frequently encountered on washer dryer models. It is usually caused by a faulty door seal, a blocked drain pipe, or a pressure switch fault.