Husqvarna Robotic Lawnmower Printed Circuit Board592909302

Unfortunately, my old pcb failed and having the guide wire plugged in caused a fault. It was an easy replacement. Just unscrew the two screws on the from of the charging station. left the top off. Unplug the power connector and then the three connectors to the pcb. The pcb is held in place with two protrusions from the top. Lift the housing slightly and the old pcb pops out top first. Then insert the new pcb into the grooves on the bottom and push the top to click into place. Reattach, the three connectors and the power cable. Screw the top back on and you should have a solid green light. Unfortunately it is an expensive part to replace.

The circuit board arrived promptly. It was very easy to fit following instructions on the internet, and my automower is now back in full working order!

I took a chance on this being the faulty part which was causing my Gardena Sileno+ to not charge. Luckily it was! My retired engineer neighbour kindly fitted the circuit board into the charging station, so I'm not sure how hard or easy it was for him (as I didn't have to do anything it was a breeze for me!). The part is pretty pricey in general, not because Ransom Spares charge an excessive amount, they were cheaper than my local Gardena specialist, but at £112 that's a 10th of what I paid for the robot mower 4 years ago. I do not know what caused the circuit board to fail but certainly do not want to keep replacing it every few years. Last August I had to get a new power cable too at nearly £100 (should have shopped around a bit more for that. Once the circuit board was recplaced it took me a while to realise I had to reset the loop signal so the mower could recognise it. That was straight forward on the mower's menu - New Loop Signal. Overall, happy with the part and happy with Ransom Spares' service.