Beko Fridge & Freezer Led Light & Temperature Thermostat Assembly

Perfect replacement but not an easy fit.

I've just replaced mine. The part is perfect but not an easy fit (not a fault of the part). The unit is clipped in but it is a VERY tight fit and requires quite a bit of force to pry it out and u clip it. At the back of the unit on the LED side, there is a small recess where you can fit a small flat blade screwdriver into. I then forced the screw driver sideways to the long side of the unit. The took a second flat blade screwdriver and did the same to the opposite side. So now you have two flat blade screwdrivers on either side of the unit (you cannot get a screwdriver in at any other point due to the tight fit and you would probably end up damaging the fridge ceiling). Now you have leverage from both screwdrivers and the idea is to try and pull the unit straight down and out. Again, it takes quite a bit of force. It will pop out. Refitting also takes quite a bit of force due to the tight fit. Try and press in the areas where the uprights are and avoid pressing on the transparent LED cover. Best to take a couple of shelves out for better access.