Neff
Neff Cooker & Hob Door Hinge Receiver00172647
Suitable for Neff, Bosch, Constructa, Junker & Ruh, Siemens
Stock Code: 46060
·
£17.20inc. VAT
£14.33 ex. VAT
In Stock
Next Day Delivery Available
Does this part fit my appliance?
Check compatibility with your model number
01
Specifications
- Part Number
- 00172647
- Alternative Part Numbers
- 00154767, 00166955
- Genuine Spare Part
- Yes
02
Description
This is a genuine door hinge receiver replacement.
Keeps your oven door steady and secure every time you open or close it. This hinge receiver holds the door hinge firmly in place, helping your oven door stay properly aligned and operate smoothly.
Over time, repeated use or forceful opening can cause the receiver to wear out, loosen, or crack. If your oven door feels unsteady, doesn’t close all the way, or starts to sag, it might be time for a new one. Replace it with this part.
This oven door hinge receiver is from Neff. Also fits Bosch, Constructa, Junker & Ruh, Siemens, and Tecnik models.
Before ordering, please verify with our compatibility checker that this part is suitable for your model.
03
Customer Reviews (5)
4.85 reviews
5
4
4
1
3
0
2
0
1
0
Did the job, but a pain to fit
I bought a pair of these receivers after replacing the hinges, which didn't fully solve the problem of the oven door not closing completely. These parts solved the problem, but they are buried inside the oven's outer casing, which needed to be removed for access.
Tim · Farnham ·
Quality
Value
Ease of Fitting
Good replacement, difficult to fit
My old hinge receivers were very worn which was preventing the oven door from fully closing. This is the correct part so I give it 5/5. However be warned this is not easy to fit! I have a built-in oven and I had to pull the oven out of the unit, and remove a lot of the screws from the side and bottom panels until there was enough flexibility in the panels to prize them apart enough to get the old part out and the new part in. Replacing these did improve the door closure, but it still wasn't tight enough to create a good seal so I had to replace the hinges too. Replacing the hinges is much much easier so I would advise anyone to try that first!
Peter · Sunbury-on-Thames ·
Quality
Value
Ease of Fitting
Neff parts
The parts were original NEFF parts that were easy to fit. Good service from Ransomspares even during COVID 19
James Hey · Oldham, OL3 6EL ·
Quality
Value
Ease of Fitting
Oven Door closes tightly once fitted.
Previously replaced hinge in oven door, but door was still not tight, with steam and heat escaping. After researching, decided to replace the hinge receiver; researched task via online videos, and descriptions, fitting is straight forward. However expect to do extra work i.e. cleaning around areas you cannot normally clean, the various vents etc. so allow for extra time. Comparing the old part to the new one, the amount of wear is quite small for the significant improvement.
Jeff T · Grantham ·
Quality
Value
Ease of Fitting
Cooker door hinge recivers
Arrived quickly and as ordered. Wouldn't hesitate to use this company in the future as I have in the past.
Iain Marsden · Corfe Mullen ·
Quality
Value
Ease of Fitting
04
Questions & Answers (1)
Is this for a pair or a single receiver.
Jim · Leicester ·
Hi Jim, this is for a single receiver as they are sold individually.
JordanStaff·