Next Day Delivery Available
Will This Part Fit My Appliance?
Choose your brand from the list below to check your model compatibility.
Start typing your model number below to check compatibility.
Part is compatible with 
We are unable to confirm if this part will fit with model number ""Description
Manufacturers Part Number:
- 2609004916
EAN Number:
- 4059952280691
Latest Product Review(s)
4 Customer Review(s)
Works fine however the part had to be machined to fit.
The Chopper Guide block works well, consequentially the shredder is back to working as well as it did when new. There was a problem in that the steel cylindrical rod was slightly larger diameter than the original and was also a few thousands of an inch longer on both ends. Both ends length had to be shortened to enable the block to be installed. It was not necessary to change the diameter. Considering the Shredder was purchased in 2009 and is back to working well I am pleased
By John Christie - Norwich
13th Jul 2023
shredder part easily fitted
The shredder part supplied was easily fitted. All good.
By STEWART SUTHERLAND - TONBRIDGE KENT
27th Jun 2022
Piece of cake!
Over the last two seasons, my Bosch shredder has worked long and hard. Then it started to clog up quite easily. l noticed that that guide plate looked worn so I ordered a replacement and found it very easy to replace. Just undo one screw and pop it out. The new guide has made such a difference with the shredder performing as new. Well worth the relatively small expense.
By Paul Lee - South Alkham
25th May 2020
Cost effective replacement
I have had a Bosch AXT 25 TC garden shredder for a fair number of years. It has a rotary cutting blade (incredibly tough) which bears on an aluminium anvil to form a cutting edge. Periodically you wind in the aluminium wedge thing to make the cutting edge sharp again. Mine had run out of adjustment but only after at least 5 years of use. It has eaten a huge amount of branches and cuttings and never failed. So was a new aluminium wedge going to work? Well it does. The shredder is working as good as new. Was it difficult to fit? No, a single Phillips screw allows a bar to be removed and the old anvil blade can be prised out (it will be a bit stiff so sue a large screwdriver judiciously). The new one drops in IF you wind back the adjustment screw so it can fit. Refit the holding bar, re-assemble and test. A few turns on the adjuster and the shredder will be back in action. RansomSpares supply a genuine Bosch part of the correct type and it has given me years more use out of this shredder. Thoroughly recommended, just order the right part number. RS497118 - guide plate.
By Brian James - Telford
29th Oct 2017
Questions And Answers
1 Answer(s)
does this part come with the 2 rubber 'o' rings (RS497105) on either side of 805, thanks?
Hi, the o ring seal is sold separately. This is part number RS497105.
1 Answer(s)
Does this plate fit the 2000 axt please? not the pathetic screw thread version the original with cutter gear. Thank you.
Hi, I'm afraid this isn't compatible with your model and we cannot supply one that is. Please accept our apologies.
1 Answer(s)
Hi there, will this part be compatible with my old Bosch 2200HP AXT (0600852042) ? The original part only seems to be available with the cutting cog. Thank you.
Hi, this plate is only available complete as a cutting head set for your model. This is part number RS496968.
